Fermax video intercom

This guide explains how to integrate a Fermax intercom with the ILEVIA server to receive calls in the ILEVIA Control app. It was written using the BLOCK PANEL 001-01 model (firmware V03.50S) and also applies to other Fermax intercoms. For the general logic, see Video intercom.

Intercom configuration

Step 1. Access the Fermax intercom web page and open the SIP settings:

1. in SIP SERVER enter the IP address of the ILEVIA server;

2. in Domain enter the ILEVIA server IP address again;

3. in STUN enter turn.ilevia.com.

Step 2. Open Advanced, enable Quick dial and enter sip:<SIP ID>@<ILEVIA server IP>, where <SIP ID> is the ID the intercom must call (the one of the app SIP Client or of a SIP Group).

Configuration in ilevia Manager

Step 1. In the Components tab, open the SIP category in the Components Library and add two SIP Client components: one for the app (in the example Ilevia Control App) and one for the intercom (Entrance intercom).

Step 2. Select the app SIP Client and fill in:

• SIP address: <SIP ID>@<ILEVIA server IP>, with the SIP ID used in Quick dial;

• SIP password: the password set on the intercom;

• For users: the users who must receive the calls.

Step 3. Select the intercom SIP Client and fill in:

• Intercom model: Generic;

• SIP address: <intercom SIP ID>@<Fermax intercom IP>;

• SIP password: the intercom SIP account password;

• IP Camera: the intercom camera (see below);

• Action 1 … 6 (optional): the scenarios to show as buttons during the call, for example gate opening.

Step 4. Upload the project to the server with Project > Upload to server.

All parameters are explained in SIP Client and SIP Group.

Intercom camera (optional)

Add an IP Camera component (category Surveillance / Security) and enter the intercom RTSP address in Local URL and Remote URL:

rtsp://<user>:<password>@<intercom IP>/mpeg/media.amp

Replace <user> and <password> with a user from the intercom web page (e.g. admin) and <intercom IP> with its address on the local network. Then connect the camera in the IP Camera field of the intercom SIP Client.

ILEVIA Control app configuration

Log in to the ILEVIA Control app with your account, then go to Settings, select Video intercom, then Device. Choose your intercom and press OK.

Test

Press the call button on the intercom. If the configuration is correct, when the app is open the call screen appears, where you can answer or reject; when the app is closed you receive a notification.